Research indexJournal article
利用高級氧化程序(AOP)處理半導體工業放流水中COD之研究
鄭成輝
1 Jan 2005
NobleIDark:/48914/w1/20260515/6C44169BDOI10.6846/tku.2005.00692
利用高級氧化程序(AOP)處理半導體工業放流水中COD之研究
鄭成輝 · 2005 · Subscription
NobleIDark:/48914/w1/20260515/6C44169BDOI10.6846/tku.2005.00692
The full text is at the publisher
You can read the abstract here, or open it at the publisher.
Abstract
Chemical Mechanical Polishing (CMP) is the most efficient planarization process in manufacturing wafers for integrated circuits manufacturing, planarizing and polishing wafer surface by chemical etching and mechanical polishing. However, CMP process consums large amount of ultra pure water producing highly contaminated hard-to-treat. To cut the cost and achieve the goal of resources recycling and environmental protection, recovering and recycling the CMP wastewater are needed. Although techniques such as traditional chemical coagulation process and membrane filtration could remove turbidity, TS, SS, heavy metals, and fluoride of CMP wastewater to meet the effluent regulations, these techniques are not effective for removing COD to meet the effluent regulation of less than 100 mg/L. This study applying advanced oxidation processes (AOP) for removing COD of CMP wastewater, aiming to find out the optimal condition for removing COD to meet the regulation. Three AOPs, Fenton process, H2O2�UV process, and H2O2�UV�Fe2+ process, were compared and tested under various concentration of H2O2, different Fe2+�H2O2 ratios, and pHs. The experiment results indicate OH radicals produced by AOPs oxidize and destroy contaminants, effectively decreasing COD of the CMP wastewater. The efficiencies of COD removal by these methods are in the order of H2O2�UV�Fe2+>Fenton>H2O2�UV . Both H2O2�UV�Fe2+ and Fenton processes could lower COD of the CMP wastewater in this study below 100mg/L within 60 minutes.