NobleBlocks

Research indexJournal article

Three-dimensional shape optimization using fully automatic mesh generation

Botkin

AIAA Journal1 Jul 1992

NobleIDark:/48914/w1/20260515/3AAB23A7DOI10.2514/3.11162

Paywalled

The full text is at the publisher

You can read the abstract here, or open it at the publisher.

Read at the publisher

Abstract

Introduction T HE technique for associating design variables with mesh data is the most crucial factor in three-dimensional shape optimization. Previously, work in three-dimensional shape optimization involved specifying design variables by associating parameters directly with grid points on an existing mesh. For realistic problems this can be a very tedious (and errorprone) process. In the past, shape optimization capabilities have been developed based on a variety of design/analysis capabilities ranging from associating parameters with a mesh created manually to associating parameters with control points of a mapped mesh generator. Special techniques have also been developed to properly move internal grid points during sensitivity calculations. More recently, a capability based on constructive solid geometry (CSG) has been developed, but CSG representations are not particularly suitable for design optimization. A new optimization approach is demonstrated in this Note that uses a new, fully automatic mesh generation capability. The design model is developed based on design-oriented geometric primitives that represent recognizable features of a part and can be assembled into complete solid models that are defined in terms of a small set of design parameters.

Discussion

Citations

Topics

More

Suggest a correction or report